Male Header Chip
A three pin male header designed to work in a LEGO or conductive sewing based environment. Press the button to add power to a circuit, release to cut off power.
Like all of our Crazy Circuits components this pin header is soldered to a small circuit board with large LEGO sized holes in it. The overall PCB size is the same as a 2x3 LEGO component. The part is designed to connect to other components in a brick based environment using our 1/8th inch wide Maker Tape.
This part can also be used with Conductive Thread for use in Soft Circuits. Just sew through the large copper plated holes to make your circuit. For quick testing you can also use alligator clips to connect this pin header to other components.
Typically this part is used to connect a standard Servo into the Crazy Circuits system, however any two pin or three pin component will work such as simple sensors or ribbon cables. (In general it's easier to just use the on board pin headers found on the Robotics Board whenever possible.)